Precaution [09/2023 - ]

Observe the following in order to prevent entry of foreign matter:

• Do not allow foreign matter such as grease, oil or water to adhere to the inside of the EV motor control inverter assembly.
• Do not use air tools in areas other than specified to prevent entry of dust.
• Prevent wind from blowing through the workshop to prevent entry of dust.
• Do not drop any bolts or tools into the rear transaxle with motor and inverter assembly.
• Clean the tools before use.

PRECAUTION WHEN HANDLING ELECTRONIC COMPONENTS

• Do not touch the terminals of the connectors or areas other than the specified on circuit boards, as static electricity may be applied to parts and damage them.
• Do not drop electronic components such as circuit boards or subject them to impact.
• Keep the removed parts free from dust.
• Electronic components are very sensitive. Be sure to observe the handling instructions.

PRECAUTION WHEN HANDLING PARTS

• Do not drop parts or subject them to impact.
• If a part is subject to impact, replace it with a new one.
• Be sure to observe the handling instructions to prevent parts from being damaged.
• If coolant adheres to the inside of the EV motor control inverter assembly, replace it with a new one.

PRECAUTION WHEN SUSPENDING WORK

• If suspending work, cover parts with clean pieces of paper to prevent entry of dust and foreign matter.