ECM Communication Stop Mode [12/2023 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR OPEN IN CAN BUS LINES (ECM MAIN LINE)
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- Disconnect the B86 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition B86-13 (CANH) - B86-26 (CANL) Cable disconnected from negative (-) auxiliary battery terminal 108 to 132 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE CAN MAIN BUS LINES OR CONNECTOR (ECM)
Result:
OK
See step 2
- CHECK ECM POWER SOURCE CIRCUIT
- Check the ECM power source circuit.
Refer to ECM Power Source Circuit [12/2023 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [12/2023 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
- Check the ECM power source circuit.