Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [12/2023 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 2 minutes or more.
3. Enter the following menus: Powertrain / Rear Motor Generator / Active Test / Control the Motor/Generator Cooling Oil Pump.
4. According to the display on the GTS, perform the Active Test and set the duty to 85%.

   HINT: 

   The Active Test cannot be performed if the duty ratio is set to 30% or lower or 90% or higher, if the ambient temperature is -11°C (12.2°F) or lower, or transmission fluid temperature sensor value is below -1°C (30.2°F) or lower.

5. According to the display on the GTS, read the Data List and check that the value of "Motor/Generator Cooling Oil Pump Motor Revolution" is between 600 rpm and 7000 rpm.
6. Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.
7. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform driving pattern again.