Inspection [12/2023 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH (FUEL PRESSURE SENSOR) NOTE:
- Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
- If the fuel pressure sensor is removed, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor) with a new one.
- Check the fuel pressure sensor output voltage.
- Apply 5 V between terminals 1 (VC) and 2 (E2).NOTE:
- Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
- Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).
HINT:
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
*a Component without harness connected
(Fuel Pressure Sensor)*b Voltage Applied between Terminals - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition 3 (PR) - 2 (E2) Pressure not applied to fuel pressure sensor Approximately 0.4 to 0.6 V* *: The output voltage changes depending on the voltage applied to the terminals.
If the result is not as specified, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor).
*a Component without harness connected
(Fuel Pressure Sensor)
- Apply 5 V between terminals 1 (VC) and 2 (E2).