Typical Enabling Conditions
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Monitor runs whenever following DTCs not stored | None |
| All of the following conditions are met | - |
| Auxiliary battery voltage | Higher than 6 V |
| Crankshaft position sensor voltage | 0.3 to 4.7 V |
| Lost communication with hybrid vehicle control ECU assembly (U0293) | Not detected |
| Hybrid vehicle control ECU assembly judges | Engine running |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Monitor runs whenever following DTCs not stored | None |
| All of the following conditions are met | - |
| Auxiliary battery voltage | Higher than 6 V |
| Crankshaft position sensor voltage | 0.3 to 4.7 V |
| Starter | Off |
| Time after starter on to off | 3 seconds or more |
| Engine speed (Top dead center) | 600 rpm or more |
| Engine speed (30°CA) | 600 rpm or more |
| Lost communication with hybrid vehicle control ECU assembly (U0293) | Not detected |
| Hybrid vehicle control ECU assembly judges | Engine running |