DTC P0220-11: Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground [12/2023 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (THROTTLE POSITION SENSOR NO. 2 VOLTAGE)
Pre-procedure1
- Read the values displayed on the GTS.
Powertrain > Engine > Data List
Tester Display Throttle Position Sensor No. 2 Voltage - Disconnect the throttle body with motor assembly connector.
- Compare the value of the Data List item Throttle Position Sensor No. 2 Voltage after disconnecting the throttle body with motor assembly connector to the value when the connector was connected.
Result
Result Proceed to Changes from less than 2.05 V to higher than 4.75 V A Does not change from less than 2.05 V B
Post-procedure1
- None.
Result:
A
REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY. Refer to REMOVAL [12/2023 - ]
Result:
B
See step 2
- Read the values displayed on the GTS.
- CHECK HARNESS AND CONNECTOR (THROTTLE POSITION SENSOR - ECM)
Pre-procedure1
- Disconnect the throttle body with motor assembly connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result C73-5 (VC) - C86-121 (VCTA) Always Below 1 Ω Ω C73-4 (VTA2) or C86-89 (VTA2) - Body ground and other terminals Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None.
Result:
OK
REPLACE ECM. Refer to REMOVAL [12/2023 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR