LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Control System - Diagnostic Codes (2 Of 6)) >> SFI System >> DTC P011B-62: Engine Coolant Temperature / Intake Air Temperature Signal Compare Failure [12/2023 - ] >> Typical Malfunction Thresholds

Typical Malfunction Thresholds

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
Both of the following conditions are met -
Deviated engine coolant temperature and intake air temperature Less than -22.5°C (-8.5°F), or higher than 22.5°C (72.5°F)
Soak monitor judgment* Fail
*: Soak monitor judgment is fail when following conditions are met -
Both of the following conditions are met A and B
A. All of the following conditions are met -
Auxiliary battery voltage 10.5 V or higher
Ignition switch Off
Soak time 5 hours or more
Either of the following conditions is met (a) or (b)
(a) Minimum intake air temperature after engine start -10°C (14°F) or higher
(b) Engine coolant temperature before engine start -10°C (14°F) or higher
Engine coolant temperature sensor circuit fail (P0117, P0118) Not detected
Intake air temperature sensor circuit fail (P0112, P0113) Not detected
Soak timer fail (P2610) Not detected
B. Deviated engine coolant temperature and intake air temperature Less than -22.5°C (-8.5°F), or higher than 22.5°C (72.5°F)