DTC P011B-62: Engine Coolant Temperature / Intake Air Temperature Signal Compare Failure [12/2023 - ]: Procedure

1. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   P011B-62 and other DTCs are output	A
   P011B-62 is output	B

   HINT: 

   If any DTCs other than P011B-62 are output, troubleshoot those DTCs first.

Result: 

A 

GO TO DTC CHART. Refer To  DIAGNOSTIC TROUBLE CODE CHART [12/2023 - ] 

Result: 

B 

See step  2

Pre-procedure1

• Leave the vehicle for 7 hours or more.

  HINT: 

  It is necessary to leave the vehicle for 7 hours or more to create conditions similar to the DTC detection conditions.

• According to the display on the GTS, read the Data List.

  Powertrain > Engine > Data List 

  Tester Display
  Intake Air Temperature

  Standard

  Difference between the intake air temperature and the actual outside air temperature is 10°C (18°F) or less.

  HINT: 

  The temperature displayed on the outside temperature gauge of the vehicle (if equipped) is not suitable for comparing to the intake air temperature reading. The outside temperature gauge has a significant delay built into prevent swings in the temperature display. Use an accurate thermometer to determine the outside air temperature.

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None.

Result: 

NG 

REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

OK 

See step  3

1. According to the display on the GTS, read the Data List.

   Powertrain > Engine > Data List 

   Tester Display
   Coolant Temperature

   Standard

   The difference between the coolant temperature and the actual outside air temperature is 10°C (18°F) or less.

   HINT: 

   If the result is not as specified, check that there are no heat sources such as a block heater in the engine compartment.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [12/2023 - ] 

Result: 

NG 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to  REMOVAL [12/2023 - ]