Typical Enabling Conditions
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
P106A
| Monitor runs whenever the following DTCs are not stored | P0106, P0107, P0108 (Manifold absolute pressure) P0400 (EGR system) P0452, P0453 (Evaporative emission system pressure sensor) |
| Time after ignition switch off | 50 minutes |
| Time after ECM started by soak-timer | 60 seconds or more |
| Auxiliary battery voltage | 8 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Engine coolant temperature | -10°C (14°F) or higher |
P106C
| Time after ignition switch off | 50 minutes |
| Time after ECM started by soak-timer | 60 seconds or more |
| Auxiliary battery voltage | 8 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Engine coolant temperature | -10°C (14°F) or higher |
| Pressure sensor of canister pump module malfunction (P0451, P0452, P0453) | Not detected |