LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Control System - Diagnostic Codes (1 Of 6)) >> SFI System >> DTC P0088-00: Fuel Rail / System Pressure - Too High [12/2023 - ] >> Procedure

DTC P0088-00: Fuel Rail / System Pressure - Too High [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0088-00) 
    1. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P0088-00 and other DTCs are output A
      P0088-00 is output B

      HINT: 

      If any DTCs other than P0088-00 are output, troubleshoot those DTCs first.

    Result: 

    GO TO DTC CHART. Refer To  DIAGNOSTIC TROUBLE CODE CHART [12/2023 - ] 

    Result: 

    See step  2

  2. CHECK FUEL PRESSURE SENSOR (FOR HIGH PRESSURE SIDE) 

    Pre-procedure1

    • Put the engine in Inspection Mode (2WD for measuring Exhaust Gas).

      Powertrain > Hybrid Control > Utility 

      Tester Display
      Inspection Mode
    • Start the engine.
    • According to the display on the GTS, read the Data List while racing the engine.

      Powertrain > Engine > Data List 

      Tester Display
      Fuel Pressure (High)

      OK

      Fuel pressure fluctuates.

      Result

      Proceed to
      OK
      NG

    Post-procedure1

    • None.

    Result: 

    NG 

    REPLACE FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH (FUEL PRESSURE SENSOR (FOR HIGH PRESSURE SIDE)). Refer to  REMOVAL [12/2023 - ] 

    Result: 

    OK 

    See step  3

  3. REPLACE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY (FOR HIGH PRESSURE SIDE) 

    HINT: 

    Refer to REMOVAL [12/2023 - ]

    Result

    Proceed to
    NEXT

    Result: 

    NEXT 

    See step  4

  4. CLEAR DTC 

    Pre-procedure1

    • None.
    • Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

      Result

      Proceed to
      NEXT

    Post-procedure1

    • Turn the ignition switch off and wait for at least 30 seconds.

    Result: 

    NEXT 

    See step  5

  5. CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0088-00 IS OUTPUT AGAIN) 

    Pre-procedure1

    • Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
    • Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P0088-00 is output A
      DTCs are not output B

    Post-procedure1

    • None.

    Result: 

    REPLACE ECM. Refer to  REMOVAL [12/2023 - ] 

    Result: 

    END