LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Control System - Diagnostic Codes (1 Of 6)) >> SFI System >> DTC P0069-00: Manifold Absolute Pressure - Barometric Pressure Correlation [12/2023 - ] >> Procedure

DTC P0069-00: Manifold Absolute Pressure - Barometric Pressure Correlation [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0069-00) 
    1. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P0069-00 and other DTCs are output A
      P0069-00 is output B

      HINT: 

      If any DTCs other than P0069-00 are output, troubleshoot those DTCs first.

    Result: 

    GO TO DTC CHART. Refer To  DIAGNOSTIC TROUBLE CODE CHART [12/2023 - ] 

    Result: 

    See step  2

  2. READ VALUE USING GTS (INTAKE MANIFOLD ABSOLUTE PRESSURE) 

    Pre-procedure1

    • Turn the ignition switch off and wait for at least 50 minutes.
    • Using the following table, determine the normal atmospheric pressure for the current altitude and temperature.
      GTY518158Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      • Standard atmospheric pressure is approximately 101 kPa(abs) [14.65 psi(abs)].
      • For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies depending on the weather.
    • Compare the value of the Data List item Intake Manifold Absolute Pressure with the actual atmospheric pressure.

      Powertrain > Engine > Data List 

      Tester Display
      Intake Manifold Absolute Pressure

      Result

      Result Proceed to
      Approximately the same as the actual atmospheric pressure A
      Not approximately the same as the actual atmospheric pressure B

    Post-procedure1

    • None.

    Result: 

    REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR. Refer to  REMOVAL [12/2023 - ] 

    Result: 

    See step  3

  3. READ VALUE USING GTS (ATMOSPHERIC PRESSURE) 
    1. Using the following table, determine the normal atmospheric pressure for the current altitude and temperature.
      GTY518158Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      • Standard atmospheric pressure is approximately 101 kPa(abs) [14.65 psi(abs)].
      • For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies depending on the weather.
    2. Compare the value of the Data List item Atmospheric Pressure with the actual atmospheric pressure.

      Powertrain > Engine > Data List 

      Tester Display
      Atmospheric Pressure

      Result

      Result Proceed to
      Approximately the same as the actual atmospheric pressure A
      Not approximately the same as the actual atmospheric pressure B

    Result: 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2023 - ] 

    Result: 

    REPLACE ECM. Refer to  REMOVAL [12/2023 - ]