LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Mechanical System (2GR-FXS) - Service Information (1 Of 3)) >> Drive Belt >> On-Vehicle Inspection [12/2023 - ] >> Procedure

On-Vehicle Inspection [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT V-RIBBED BELT 
    1. Check the V-ribbed belt for wear, cracks or other signs of damage.
      GTY618175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. If any of the following defects is found, replace the V-ribbed belt.
      • The V-ribbed belt is cracked.
      • The V-ribbed belt is worn out to the extent that the cords are exposed.
      • The V-ribbed belt has chunks missing from the ribs.
    3. Check that the V-ribbed belt fits properly in the ribbed grooves.
      GTY675000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect
    4. Check with your hand to confirm that the V-ribbed belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.
scientia non olet · About LEMON Manuals