Caution / Notice / Hint
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Gas leak from exhaust system is repaired | Inspection after repair |
|
Refer to INITIALIZATION [12/2023 - ] |
COMPONENTS (REMOVAL)
| Procedure | Part Name Code | ||||
|---|---|---|---|---|---|
| 1 | EXHAUST MANIFOLD ASSEMBLY LH | 17150 | - | - | - |
| 2 | WATER HOSE CLAMP | 16581 | - | - | - |
| 3 | CRANKSHAFT POSITION SENSOR PROTECTOR | 19312 | - | - | - |
| 4 | CRANKSHAFT POSITION SENSOR | 11401G | See step 4 | - | - |
| • | Non-reusable part | - | - |