LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Hybrid Battery Control System - Service Information (3 Of 3)) >> HEATER RELAY (for PHEV Model) >> Inspection [12/2023 - ] >> Procedure

Inspection [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+ and 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT NO. 1 TRACTION BATTERY HEATER RELAY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1(BH0) -3(HR0) Auxiliary battery voltage not applied between terminals 11(BHR) and 8(BHRG) 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 11(BHR) and 8(BHRG) Below 1 Ω
      6(BH1) -4(HR1) Auxiliary battery voltage not applied between terminals 11(BHR) and 8(BHRG) 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 11(BHR) and 8(BHRG) Below 1 Ω

      If the result is not as specified, replace the No. 1 traction battery heater relay.

      GTY1205937Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 1 traction battery heater relay)
scientia non olet · About LEMON Manuals