Installation [12/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the No. 2 liquid tube.

      Compressor Oil

      ND-OIL 11 or equivalent

      NOTE:

      Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.

   2. Install the 2 O-rings to the No. 2 liquid tube.
      NOTE:

      Keep the O-ring and O-ring fitting surface free of foreign matter.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the No. 1 magnet valve assembly to the No. 2 liquid tube with the bolt.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Using a 5 mm hexagon socket wrench, install the No. 2 magnet valve assembly and No. 1 liquid tube to the No. 2 liquid tube with the bolt.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the No. 2 liquid tube.

      Compressor Oil

      ND-OIL 11 or equivalent

      NOTE:

      Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.

   2. Install the O-ring to the No. 2 liquid tube.
      NOTE:

      Keep the O-ring and O-ring fitting surface free of foreign matter.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the No. 2 liquid tube to the No. 3 magnet valve assembly with the bolt.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

See step  1

Refer to INSTALLATION [12/2023 - ]