Installation [12/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Sufficiently apply compressor oil to a new O-ring and the fitting surfaces of the air conditioning pressure sensor.

      Compressor Oil

      ND-OIL 11 or equivalent

      NOTE:

      Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.

   2. Install the O-ring to the air conditioning pressure sensor.
      NOTE:

      Keep the O-rings and O-ring fitting surfaces free from dirt and foreign matter.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Turn

   -

   -

   1. Secure the air conditioning pressure sensor in a vise between aluminum plates.
      NOTE:

      • Do not apply excessive force to the pipe.
      • Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
      • Do not damage the sealant or brazed area at the base of the piping.

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        *1	Air Conditioning Pressure Sensor
        *2	Sealant or Brazed Area

   2. Using a 27 mm deep socket wrench, install the air conditioning pressure sensor as shown in the illustration.

      Torque: 10.8 N.m (110 kgf/cm, 8 ft.lbf) 

      NOTE:

      Do not apply excessive force to the pipe.

See step  1

Refer to INSTALLATION [12/2023 - ]