Removal [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fully apply the parking brake and chock a wheel.
WARNING:
- Make sure to apply the parking brake and chock a wheel before performing this procedure.
- If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 6

DISCONNECT MOTOR COOLING COOLER

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY

NOTE:

When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.

Do not rotate the spline part (*a) of the shift control actuator assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE SHIFT CONTROL ACTUATOR SEAL

NOTE:

Remove all fragments of the shift control actuator seal.
The shift control actuator seal may remain attached to the hybrid vehicle transaxle assembly side. Make sure to remove it.
Do not use a sharp tool such as a scraper.

HINT:

Perform this procedure only when replacement of the shift control actuator seal is necessary.