Installation [12/2023 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PUMP WITH MOTOR ASSEMBLY
Torque: 19.5 N.m (199 kgf/cm, 14 ft.lbf)
- CONNECT NO. 1 MOTOR COOLING HOSE
*a 0 to 3 mm (0 to 0.118 in.) *b 2 to 7 mm (0.0787 to 0.276 in.) *c Paint Mark *d Marking *e Center of Paint Mark *f 45° (Claw of Clip Location) - Connect the No. 1 motor cooling hose to the oil pump with motor assembly, and slide the clip to secure it.NOTE:
- Make sure to slide the No. 1 motor cooling hose until it contacts the hose stopper of the oil pump with motor assembly.
- Make sure to align the paint mark of the No. 1 motor cooling hose with the marking of the oil pump with motor assembly.
- Make sure that the clip is within the location shown in the illustration.
- Connect the No. 1 motor cooling hose to the oil pump with motor assembly, and slide the clip to secure it.
- CONNECT NO. 2 MOTOR COOLING HOSE
*a 0 to 3 mm (0 to 0.118 in.) *b 2 to 7 mm (0.0787 to 0.276 in.) *c Paint Mark *d Marking *e Center of Paint Mark *f 45° (Claw of Clip Location) - Connect the No. 2 motor cooling hose to the oil pump with motor assembly and slide the clip to secure it.NOTE:
- Make sure to slide the No. 2 motor cooling hose until it contacts the hose stopper of the oil pump with motor assembly.
- Make sure to align the paint mark of the No. 2 motor cooling hose with the marking of the oil pump with motor assembly.
- Make sure that the clip is within the location shown in the illustration.
- Connect the No. 2 motor cooling hose to the oil pump with motor assembly and slide the clip to secure it.
- INSPECT HYBRID TRANSAXLE FLUID
See step 2
- INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
See step 3
- INSTALL INLET AIR CLEANER ASSEMBLY
- INSTALL COOL AIR INTAKE DUCT SEAL
- INSTALL SUSPENSION TOWER DAMPER
Refer to INSTALLATION [12/2023 - ]