LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Hybrid Transaxle System (P810) - Service Information) >> Motor Cable >> Removal [12/2023 - ] >> Procedure

Removal [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE HYBRID MOTOR CONTROL INVERTER ASSEMBLY 

    Refer to REMOVAL [12/2023 - ]

  2. REMOVE CONNECTOR COVER 
    WARNING:

    Be sure to wear insulated gloves.
    1. GTY1235494Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE TERMINAL CAP 
    WARNING:

    Be sure to wear insulated gloves.
    1. GTY1235490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    NOTE:
    • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
    • Do not touch the waterproof seal or terminals of the motor cable.
    • Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.
    1. GTY1232000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Waterproof Seal - -
      1. Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.
scientia non olet · About LEMON Manuals