LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Hybrid Transaxle System (P810) - Service Information) >> Motor Cable >> Installation [12/2023 - ] >> Procedure

Installation [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    NOTE:
    • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
    • Do not touch the waterproof seal or terminals of the motor cable.
    1. GTY1232000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Waterproof Seal - -
      1. Using an insulated tool, install the motor cable to the hybrid vehicle transaxle assembly with the 6 bolts.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. INSTALL TERMINAL CAP 
    WARNING:

    Be sure to wear insulated gloves.

    NOTE:
    • Keep the terminal cap and its installation area free from foreign matter, water, etc.
    • Do not pinch the O-ring.
    • Check that the terminal cap is securely installed.
  3. INSTALL CONNECTOR COVER 
    WARNING:

    Be sure to wear insulated gloves.
    1. GTY1240275Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Temporarily install the connector cover to the hybrid vehicle transaxle assembly with the 2 bolts.
      2. Tighten the 2 bolts to install the connector cover.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  4. INSTALL HYBRID MOTOR CONTROL INVERTER ASSEMBLY 

    Refer to INSTALLATION [12/2023 - ]

scientia non olet · About LEMON Manuals