Caution / Notice / Hint
WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH or front drive shaft oil seal RH removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Suspension parts | Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | Refer to CALIBRATION [09/2023 - ] |
| Parking assist ECU initialization | Panoramic View Monitor System | Refer to CALIBRATION [09/2023 - ] | |
| Advanced Park | Refer to CALIBRATION [09/2023 - ] | ||
w/ Automatic Headlight Beam Level Control System:
|
Lighting System (EXT) | Refer to INITIALIZATION [09/2023 - ] | |
| Tires |
|
Tire Pressure Warning System | Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) table below Refer to WORK PROCEDURE [12/2023 - ] |
| Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | Refer to CALIBRATION [09/2023 - ] | |
| Parking assist ECU initialization | Panoramic View Monitor System | Refer to CALIBRATION [09/2023 - ] | |
| Advanced Park | Refer to CALIBRATION [09/2023 - ] | ||
| Front wheel alignment adjustment | Perform "Calibration" |
|
Refer to RESET MEMORY / CALIBRATION [09/2023 - ] |
*1: Also necessary after performing a tire rotation.
*2: It is not necessary to perform this procedure if the tire pressure warning valve and transmitters are installed to the same location.