DTC P2D44-96: A/C Compressor Component Internal Failure [12/2023 - ]: Procedure
- CHECK FOR DTC
- Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
HINT:
Check even when the DTCs detected for temporary failures.
Result
Result Proceed to Only P2D44-96 is output A P2D44-96 and B1422-00 are output B P2D44-96 and B1471-1C are output C P2D44-96 and B1472-1C are output D P2D44-96 and B1474-4B are output E P2D44-96 and B1474-96 are output F Relevant DTC B1422-00 A/C Inverter Load Malfunction B1471-1C A/C Inverter High Voltage Power Resource Circuit Voltage Out of Range B1472-1C A/C Inverter High Voltage Output Circuit Voltage Out of Range B1474-4B A/C Inverter Cooling/Heating Over Temperature B1474-96 A/C Inverter Component Internal Failure
Result:
B
GO TO DTC CHART (B1422-00). Refer to DTC B1422-00: A/C Inverter Load Malfunction [12/2023 - ]
Result:
C
GO TO DTC CHART (B1471-1C). Refer to DTC B1471-1C: A/C Inverter High Voltage Power Resource Circuit Voltage Out of Range [12/2023 - ]
Result:
D
GO TO DTC CHART (B1472-1C). Refer to DTC B1472-1C: A/C Inverter High Voltage Output Circuit Voltage Out of Range [12/2023 - ]
Result:
E
GO TO DTC CHART (B1474-4B). Refer to DTC B1474-4B: A/C Inverter Cooling/Heating Over Temperature [12/2023 - ]
Result:
F
GO TO DTC CHART (B1474-96). Refer to DTC B1474-96: A/C Inverter Component Internal Failure [12/2023 - ]
Result:
A
See step 2
- Check for DTCs.
- CHECK COMPRESSOR WITH MOTOR ASSEMBLY
- Perform the Active Test according to the display on the GTS.
Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Compressor Target Speed This test drives the compressor to selected target speed.
(Compressor with motor assembly)800: Min
10000: Max (every 100)Operate with the ignition switch ON (READY) and the vehicle stopped. Body Electrical > Air Conditioner > Active Test
Tester Display Compressor Target Speed - Read the Data List according to the display on the GTS.
Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Compressor Target Speed Compressor target speed 0 to 10000 rpm Compressor target speed displayed Compressor operating - Compressor with motor assembly
Compressor Actual Speed Compressor actual speed 0 to 10000 rpm Actual compressor speed displayed Compressor operating - Compressor with motor assembly
Body Electrical > Air Conditioner > Data List
Tester Display Compressor Target Speed Compressor Actual Speed OK
The Compressor actual speed is approximately the same as the Compressor target speed.
HINT:
The Compressor Actual Speed may not run with Compressor Target Speed due to the protection control.In this case, the compressor is working without issues if the compressor actual speed increases with Compressor Target Speed to a certain extent and runs at a constant value.
Result
Proceed to OK NG
Result:
OK
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2023 - ]
Result:
NG
REPLACE COMPRESSOR WITH MOTOR ASSEMBLY. Refer to REMOVAL [12/2023 - ]
- Perform the Active Test according to the display on the GTS.