Caution / Notice / Hint
WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced when repairing air leaks in the intake system are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Air leak from intake system is repaired | Inspection After Repair |
|
Refer to INITIALIZATION [09/2023 - ] |
WARNING:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- When working near the engine room while the engine has started or the ignition switch ON, do not touch the V-ribbed belt or rotating components such as the fan, etc.
- Touching the water pump and crankshaft pulley V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.