LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Engine Control System - Diagnostic Codes (6 Of 7)) >> SFI SYSTEM (for 1Motor-HEV Model) >> DTC P2182-2A: Engine Coolant Temperature Sensor 2 Signal Stuck In Range [09/2023 - ] >> Procedure

DTC P2182-2A: Engine Coolant Temperature Sensor 2 Signal Stuck In Range [09/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2182-2A) 
    1. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P2182-2A and other DTCs are output A
      P2182-2A is output B

      HINT: 

      If any DTCs other than P2182-2A are output, troubleshoot those DTCs first.

    Result: 

    GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2023 - ] 

    Result: 

    See step  2

  2. INSPECT ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE) 

    Refer to INSPECTION [09/2023 - ]

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to  REMOVAL [09/2023 - ] 

    Result: 

    OK 

    See step  3

  3. READ VALUE USING GTS (COOLANT TEMPERATURE SENSOR1, COOLANT TEMPERATURE SENSOR2) 
    1. Compare Data List items "Coolant Temperature Sensor1" and "Coolant Temperature Sensor2" when the engine is warmed up from an engine coolant temperature below 60°C (140°F) to 60°C (140°F) or higher.

      Powertrain > Engine > Data List 

      Tester Display
      Coolant Temperature Sensor1
      Coolant Temperature Sensor2

      Result

      Result Proceed to
      Both Coolant Temperature Sensor1 and Coolant Temperature Sensor2 rise A
      Both Coolant Temperature Sensor1 and Coolant Temperature Sensor2 do not rise B
      Coolant Temperature Sensor2 does not rise C

    Result: 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2023 - ] 

    Result: 

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to  REMOVAL [09/2023 - ] 

    Result: 

    See step  4

  4. CLEAR DTC 

    Pre-procedure1

    • None
    • Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

      Result

      Proceed to
      NEXT

    Post-procedure1

    • Turn the ignition switch off.

    Result: 

    NEXT 

    See step  5

  5. CHECK WHETHER DTC OUTPUT RECURS (DTC P2182-2A) 

    Pre-procedure1

    • With the engine stopped, leave the vehicle as is for 5 hours or more.
    • Put the engine in Inspection Mode (for measuring Exhaust Gas).

      Powertrain > Hybrid Control > Utility 

      Tester Display
      Inspection Mode
    • Start the engine and warm it up until the engine coolant temperature reaches 60°C (140°F) or higher.
    • Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P2182-2A and other DTCs are output A
      P2182-2A is output B
      DTCs are not output C

    Post-procedure1

    • None

    Result: 

    GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2023 - ] 

    Result: 

    REPLACE WATER CONTROL VALVE. Refer to  REMOVAL [09/2023 - ] 

    Result: 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2023 - ]