LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Control System - Diagnostic Codes (4 Of 7)) >> SFI SYSTEM (for 1Motor-HEV Model) >> DTC P0446-73: EVAP System Vent Valve Stuck Closed Actuator Stuck Closed [09/2023 - ] >> DTC Summary

DTC Summary

WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from Priority Note
P0446-73 EVAP System Vent Valve Stuck Closed Actuator Stuck Closed Following condition is met during key-off EVAP monitor:
  • EVAP pressure change when vent valve on (closed) less than 0.3 kPa [0.04 psi]
  • Canister pump module (reference orifice, leak detection pump, vent valve)
  • Connector or wire harness (Canister pump module - ECM)
  • Canister (filter inside canister clogged)
  • ECM
Comes on Engine A
  • SAE Code: P2422
  • DTC for Mexico Models: Does not apply
DTC No. Monitoring Item Detection Timing Detection Logic SAE
P0446-73 Vent valve (built into canister pump module) stuck closed EVAP monitoring
(ignition switch off)
2 trip P2422

HINT: 

The vent valve is built into the canister pump module.