DTC P0115-11: Engine Coolant Temperature Sensor 1 Circuit Short to Ground [09/2023 - ]: Description
A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor.
Refer to DTC P0110-11.
Refer to DESCRIPTION
HINT:
When DTC P0115-11 is stored, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|
| P0115-11 | Engine Coolant Temperature Sensor 1 Circuit Short to Ground | The engine coolant temperature sensor (for outlet side) output voltage is less than 0.142 V for 0.5 seconds or more (1 trip detection logic). |
|
Comes on | Engine | A |
|
HINT:
When a DTC is output, check the Data List item "Coolant Temperature" using the GTS.
Refer to DATA LIST / ACTIVE TEST [09/2023 - ]
| DTC No. | Coolant Temperature | Malfunction |
|---|---|---|
| P0115-11 | Higher than 135°C (275°F) | Short to ground in THW circuit |
If the Data List displays a normal value, the normal value may be due to a temporary recovery from the malfunction condition. Check for intermittent problems.