Installation [09/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Apply a small amount of engine oil to the O-ring of the oil pressure control valve assembly.
   2. Using an 8 mm socket wrench, install the oil pressure control valve assembly to the timing chain cover assembly with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:

      • When reusing the oil pressure control valve assembly, inspect the O-ring.
      • Make sure that the O-ring is not cracked or does not move out of place during installation.
   3. Connect the oil pressure control valve assembly connector.

Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

Refer to PROCEDURE - Step 6

For 1Motor-HEV Model:

Refer to PROCEDURE - Step 80

For Gasoline Model:

Refer to PROCEDURE - Step 89