Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced when repairing air leaks in the intake system are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Air leaks from intake system is repaired	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [09/2023 - ]

WARNING:

Fig 1: Prevent Injury Due To Contact With An Operating V-Ribbed Belt Or Cooling Fan

When working near the engine room while the engine has started or the ignition switch ON, do not touch the V-ribbed belt or rotating components such as the fan, etc.
Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.