Inspection [09/2023 - ]: Procedure
- INSPECT BACK DOOR CONTROL SWITCH
- Check the switch.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Back Door Control Switch)Standard Resistance
Tester Connection Condition Specified Condition Result M11-5 (CLLS) - M11-2 (E) Pressed (On) Below 1 Ω Ω M11-5 (CLLS) - M11-2 (E) Not pressed (Off) 10 kΩ or higher kΩ If the result is not as specified, replace the back door control switch.
- Measure the resistance according to the value(s) in the table below.
- Check the switch illumination.
- Apply auxiliary battery voltage to the switch connector and check that the back door control switch illuminates.
OK
Tester Connection Condition Specified Condition Auxiliary battery positive (+) - M11-6 (ILL+)
Auxiliary battery negative (-) - M11-1 (ILL-)Always Switch illumination illuminates If the result is not as specified, replace the back door control switch.
- Apply auxiliary battery voltage to the switch connector and check that the back door control switch illuminates.
- Check the switch.