Removal [08/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to REMOVAL [08/2023 - ]

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   -

   -

   1. Disconnect each connector from the spiral cable with sensor sub-assembly and steering wheel assembly.
   2. Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.
   3. Put matchmarks on the steering wheel assembly and steering main shaft.
   4. Temporarily install the steering wheel assembly set bolt.
      NOTE:

      Do not overtighten the steering wheel assembly set bolt.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Turn

   *b

   Hold

   1. Using SST, separate the steering wheel assembly.
      • SST: 09950-50013 
        1. 09951-05010
        2. 09952-05010
        3. 09953-05020
        4. 09954-05031
        5. 09957-04010
      • SST: 09950-60011 
        1. 09951-00330
      NOTE:

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

   2. Remove the steering wheel assembly set bolt and steering wheel assembly.

See step  3

for UA81E, UA81F: Refer to PROCEDURE - Step 3

for P810: Refer to PROCEDURE - Step 3

for PC60: Refer to PROCEDURE - Step 3

for UA81E, UA81F: Refer to PROCEDURE - Step 4

for P810: Refer to PROCEDURE - Step 4

for PC60: Refer to PROCEDURE - Step 4