Removal [10/2022 - ]: Procedure

Refer to PROCEDURE - Step 1 [10/2022 - 08/2023] , or refer to PROCEDURE - Step 1 [08/2023 - ] [08/2023 - ]

Refer to REMOVAL [10/2022 - ]

Refer to REMOVAL [10/2022 - ]

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
   2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.
   2. Remove the O-ring from the discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Disconnect the connector.
2. for Type A:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 2 bolts and 2 nuts.
   2. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.
3. for Type B:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 4 bolts and compressor assembly with pulley.