LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Control System - Diagnostic Codes (01 Of 10)) >> SFI SYSTEM (for Gasoline Model) >> DTC P0088-00: Fuel Rail / System Pressure - Too High [10/2022 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

  1. Record the Freeze Frame Data.
  2. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  3. Turn the ignition switch off and wait for at least 30 seconds.
  4. Start the engine.
  5. Based on the engine speed, engine load, injection mode and other conditions displayed in the Freeze Frame Data, reproduce the conditions present when the DTC was stored.
  6. Enter the following menus: Powertrain / Engine / Trouble Codes.
  7. Read the pending DTCs.

    HINT: 

    • If a pending DTC is output, the system is malfunctioning.
    • If a pending DTC is not output, perform the following procedure.
  8. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
  9. Input the DTC: P0088-00.
  10. Check the DTC judgment result.

    HINT: 

    • If the judgment result is NORMAL, the system is normal.
    • If the judgment result is ABNORMAL, the system has a malfunction.