DTC P0110-11: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Ground [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS)
Pre-procedure1
- Disconnect the mass air flow meter sub-assembly connector.
- According to the display on the GTS, read the Data List.
*1 Mass Air Flow Meter Sub-assembly *2 ECM Powertrain > Engine > Data List
Tester Display Intake Air Temperature Result
Result Proceed to The value of Intake Air Temperature is -40 °C A None of the above conditions are met B HINT:
-40°C = -40°F
Post-procedure1
- None.
Result:
A
REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL [10/2022 - ]
Result:
B
See step 2
- CHECK HARNESS AND CONNECTOR (MASS AIR FLOW METER SUB-ASSEMBLY - ECM)
Pre-procedure1
- Disconnect the mass air flow meter sub-assembly connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result B14-4 (THA) or B27-76 (THA) - Body ground and other terminals Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None.
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR