Confirmation Driving Pattern

HINT: 

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

  Refer to DTC CHECK / CLEAR [08/2023 - ]

• When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.

  Refer to DTC CHECK / CLEAR [08/2023 - ]

1. Connect the GTS to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the GTS on.
4. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
5. Turn the ignition switch off and wait for at least 30 seconds.
6. Turn the ignition switch to ON (READY) [A].
7. Turn the GTS on.
8. Check that the following conditions are met and perform the Active Test according to the display on the GTS. [B]

   Enter the following menus: Powertrain / HV Battery / Active test / Hybrid/EV Battery Refrigerant Cooling Control.

   CONDITION
   
   

   Ambient temperature	5 °C or higher
   Operation time	10 minutes

   HINT: 

   • In order to perform "Hybrid/EV Battery Refrigerant Cooling Control", the HV battery minimum temperature must be 20°C (68°F) and the refrigerant temperature must be 20°C (68°F) or higher.

     If the above conditions are not established, perform the "Hybrid/EV Battery Heater Relay" Active Test in an environment with an ambient temperature of 5°C (41°F) or higher and increase the HV battery temperature.

     The temperature will drop after the heater is stopped, so increase the values of "Hybrid/EV Battery Temperature 1 to 20, Hybrid/EV Battery Refrigerant Temperature (Duct Outlet 1), Hybrid/EV Battery Refrigerant Temperature (Duct Outlet 2)" in the Data List to 21°C (70°F) or higher.

     (At an ambient temperature of 5°C (41°F), "Hybrid/EV Battery Heater Relay" will need to be performed for approximately 10 hours.)

   • Perform this step with the A/C blower switch off.
9. Wait 5 minutes or more. [C]
10. Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes [D].
11. Read the pending DTCs.

    HINT: 

    • If a pending DTC is output, the system is malfunctioning.
    • If a pending DTC is not output, perform the following procedure.
12. Enter the following menus: Body Electrical / Air Conditioner / Utility / All Readiness.
13. Input the DTC: B1385-71.
14. Check the DTC judgment result.

    GTS Display	Description
    NORMAL	DTC judgment completed System normal
    ABNORMAL	DTC judgment completed System abnormal
    INCOMPLETE	DTC judgment not completed Perform driving pattern after confirming DTC enabling conditions

    HINT: 

    • If the judgment result is NORMAL, the system is normal.
    • If the judgment result is ABNORMAL, the system is malfunctioning.
    • If the judgment result is INCOMPLETE, perform steps [B] through [D] again.
    • [A] to [D]: Normal judgment procedure.

      The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

    • When clearing the permanent DTCs, do not disconnect the cable from the auxiliary battery terminal or attempt to clear the DTCs during this procedure, as doing so will clear the universal trip and normal judgment histories.