Confirmation Driving Pattern

HINT: 

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

Refer to UTILITY [10/2022 - ]

1. Turn the ignition switch to ON (READY).
2. Depress the brake pedal and slowly change the shift state from N to R to N to D to S to the home position.
3. Press the P position switch to change the shift state to P.
4. Turn all switches off and turn the ignition switch off.
5. Disconnect the GTS.
6. Wait for 5 minutes or more with the door lock locked.

   HINT: 

   • Once the door lock is locked, keep the electrical key transmitter sub-assembly (electrical key) 3 m (9.84 ft.) or more away from the vehicle.
   • Because the system will not sleep while any door and/or the hood is open, take steps such as securing the courtesy switch to make the system recognize the doors and hood as closed when carrying out the operation.
   • If the vehicle is equipped with a power back door, the system will not sleep if the back door is not closed. Ensure that the back door is closed before carrying out the operation.
7. Turn the ignition switch to ON (READY).
8. Depress the brake pedal and slowly change the shift state from N to R to N to D to S to the home position.
9. Press the P position switch to change the shift state to P.