LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Service Information) >> Water Pump >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [10/2022 - 08/2023] , or refer to REMOVAL [08/2023 - ] 

  2. REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) 
    1. GTY1077999Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the sensor wire connector.
      2. Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).
    2. GTY1078499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals