New Key Registration Warning Message is not Displayed [10/2022 - ]: Procedure

1. Check for DTCs.

   Body Electrical > Smart Access > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2022 - ] 

Result: 

A 

See step  2

1. Read the Data List according to the display on the GTS.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   FL Door Courtesy Switch Status	Front door LH courtesy light switch signal	OFF or ON	OFF: Front door LH closed ON: Front door LH open	-

   Body Electrical > Main Body > Data List 

   Tester Display
   FL Door Courtesy Switch Status

   Result

   Result	Proceed to
   On the GTS screen, ON or OFF is displayed accordingly.	A
   On the GTS screen, ON or OFF is not displayed accordingly.	B

Result: 

B 

GO TO E-LATCH SYSTEM (Door Courtesy Switch Circuit). Refer to  Door Courtesy Switch Circuit [10/2022 - ] 

Result: 

A 

See step  3

1. With the electrical key transmitter sub-assembly in the vehicle and all of the doors closed, lock the doors using the entry lock function and check that the warning message is displayed on the multi-information display.
   NOTE:

   In order to prevent the electrical key transmitter sub-assembly from being locked inside the vehicle, perform this inspection with the window of a door open.

   HINT: 

   Key lock-in prevention function (vehicle interior).

   Refer to OPERATION CHECK [10/2022 - ]

   Result

   Result	Proceed to
   The warning message is displayed on the multi-information display.	A
   The warning message is not displayed on the multi-information display.	B

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2022 - 10/2024]  , or refer to  REMOVAL [10/2024 - ] 

Result: 

A 

See step  4

1. Clear all of the registered electrical key transmitter sub-assemblies except one and perform registration again.

   Refer to REGISTRATION [10/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. With all of the doors closed, lock the doors using the entry lock function.
2. Unlock the doors using the entry unlock function, open the driver door and check that the warning message is displayed on the multi-information display.

   Result

   Result	Proceed to
   The warning message is displayed on the multi-information display.	A
   The warning message is not displayed on the multi-information display.	B

Result: 

A 

END (10 DAYS MAY HAVE ELAPSED SINCE AN ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY WAS REGISTERED) 

Result: 

B 

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to  REMOVAL [10/2022 - 08/2023]  , or refer to  REMOVAL [08/2023 - ]