DTC P2BE4-28: Hybrid/EV Battery Pack Current Sensor "C" Circuit Range/Performance Signal Bias Level Out of Range / Zero Adjustment Failure [08/2023 - ]: Description
WARNING: This page is about a different car, the 2025 Lexus RX 450h+ and 2024 Lexus RX 450h+. However, it is still accessible from the selected car via links, so may be relevant.
Refer to the description for DTC P0ABF-11.
Refer to DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|---|
| P2BE4-28 | Hybrid/EV Battery Pack Current Sensor "C" Circuit Range/Performance Signal Bias Level Out of Range / Zero Adjustment Failure | The offset value of the battery current sensor is excessively large. (1 trip detection logic) |
|
Comes on | Master Warning: Comes on |
HV Battery | A | SAE Code: P2BE5 |
When the ignition switch is ON, normally the HV battery current does not flow. If the HV battery current value is above the specification, this DTC will be stored.
HINT:
- Make sure to perform Current Sensor Offset Learning after replacing a battery current sensor.
Refer to PROCEDURE - Step 4
- This DTC may be output if Current Sensor Offset Learning has not been completed.