Removal [10/2022 - 10/2024]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE INTAKE MANIFOLD
Refer to REMOVAL [10/2022 - 08/2023] , or refer to REMOVAL [08/2023 - ]
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the crankshaft position sensor.
1. Remove the O-ring from the crankshaft position sensor.
NOTE:- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.