Installation [10/2022 - 10/2024]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	O-ring	-	-
   *a	Seam	*b	Crankshaft Position Sensor Tip
   *c	OK	*d	NG

   1. Perform this procedure only when reusing the crankshaft position sensor.

      1. Clean the O-ring groove of the crankshaft position sensor.

      NOTE:

      Make sure the O-ring groove is free of foreign matter.

      2. Install a new O-ring to the crankshaft position sensor.

      NOTE:

      Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.

      3. Check if the O-ring is twisted.

      HINT: 

      Check the entire circumference of the seam of the O-ring for twisting.

   2. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
   3. Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      NOTE:

      • If the crankshaft position sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
   4. Connect the crankshaft position sensor connector.

Refer to INSTALLATION [10/2022 - 08/2023] , or refer to INSTALLATION [08/2023 - ]