LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Hybrid Transaxle System (P810) - Service Information (1 Of 2)) >> Motor Cable >> Removal [10/2022 - 08/2023] >> Procedure

Removal [10/2022 - 08/2023]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE HYBRID MOTOR CONTROL INVERTER ASSEMBLY 

    Refer to REMOVAL [10/2022 - ]

  2. REMOVE CONNECTOR COVER 
    WARNING:

    Be sure to wear insulated gloves.
    1. GTY1128092Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE TERMINAL CAP 
    WARNING:

    Be sure to wear insulated gloves.
    1. GTY1128090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    NOTE:
    • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
    • Do not touch the waterproof seal or terminals of the motor cable.
    • Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.
    1. GTY1128749Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Waterproof Seal - -
      1. Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.
scientia non olet · About LEMON Manuals