LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Electronically Controlled Brake System - Diagnostic Codes (1 Of 2)) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) >> Inspection [10/2022 - ] >> Procedure

Inspection [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY1124745Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      VSC OFF Switch (Electric Parking Brake Switch Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition Result
      C29-4 (+) - C29-7 (E) Switch pushed Below 1 Ω Ω
      C29-4 (+) - C29-7 (E) Switch not pushed 10 kΩ or higher
  2. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY1124747Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      Brake Hold Switch (Electric Parking Brake Switch Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition Result
      C29-3 (+B) - C29-7 (E) Switch pushed Below 1 Ω Ω
      C29-3 (+B) - C29-7 (E) Switch not pushed 10 kΩ or higher
  3. INSPECT DOWNHILL ASSIST CONTROL SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY1124746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      Downhill Assist Control Switch (Electric Parking Brake Switch Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition Result
      C29-13 (B) - C29-7 (E) Switch pushed Below 1 Ω Ω
      C29-13 (B) - C29-7 (E) Switch not pushed 10 kΩ or higher
  4. INSPECT BRAKE VACUUM CHECK VALVE ASSEMBLY 
    1. Check that there is ventilation from the booster side to the engine side, and no ventilation from the engine side to the booster side of the brake vacuum check valve assembly.
      GTY943753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Ventilation
      *b No Ventilation
      *c Engine Side
      *d Brake Booster Assembly Side