LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Hybrid Transaxle System (P810) - Service Information (2 Of 2)) >> Shift Control Actuator >> Removal [10/2022 - 08/2023] >> Procedure

Removal [10/2022 - 08/2023]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. GTY1060588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Fully apply the parking brake and chock a wheel.
        WARNING:
        • Make sure to apply the parking brake and chock a wheel before performing this procedure.
        • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8

  4. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  5. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10

  6. REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY 
    NOTE:
    • When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.
    • Do not rotate the spline part (*a) of the shift control actuator assembly.
      GTY1065900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. GTY1128125Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE SHIFT CONTROL ACTUATOR SEAL 
    NOTE:
    • Remove all fragments of the shift control actuator seal.
    • The shift control actuator seal may remain attached to the hybrid vehicle transaxle assembly side. Make sure to remove it.
    • Do not use a sharp tool such as a scraper.

    HINT: 

    Perform this procedure only when replacement of the shift control actuator seal is necessary.

    1. GTY1060378Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE SHIFT CONTROL ACTUATOR BRACKET 

    HINT: 

    Perform this procedure only when replacement of the shift control actuator bracket is necessary.

    1. GTY1207603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals