LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Hybrid Transaxle System (P810) - Service Information (2 Of 2)) >> Manual Parking Lock Release >> Operation Method [10/2022 - 08/2023] >> Procedure

Operation Method [10/2022 - 08/2023]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  4. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. DISCONNECT NO. 2 VENTILATION HOSE 

    Refer to PROCEDURE - Step 5

  6. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 6

  7. REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY 

    See step  6

  8. MANUAL PARKING LOCK RELEASE 
    1. Using a pair of pliers, grip the parking lock shaft that has been wrapped with a cloth or other material and rotate it approximately 20° in the direction shown by the arrow in the illustration to release the parking lock.
      GTY1122926Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 2-flats Portion of Parking Lock Shaft
      *b Spline Portion of Parking Lock Shaft
      *c Rotate Approximately 20°
      NOTE:
      • Do not grip the 2-flats portion (*a) of the parking lock shaft.
      • Make sure to use a cloth or other material to prevent damage to the spline portion (*b) of the parking lock shaft.
  9. MANUAL PARKING LOCK 
    1. Using a pair of pliers, grip the parking lock shaft that has been wrapped with a cloth or other material and rotate it approximately 20° in the direction shown by the arrow in the illustration to apply the parking lock.
      GTY1127757Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 2-flats Portion of Parking Lock Shaft
      *b Spline Portion of Parking Lock Shaft
      *c Rotate Approximately 20°
      NOTE:
      • Do not grip the 2-flats portion (*a) of the parking lock shaft.
      • Make sure to use a cloth or other material to prevent damage to the spline portion (*b) of the parking lock shaft.
scientia non olet · About LEMON Manuals