Replacement [08/2023 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
Refer to REMOVAL [08/2023 - 10/2024] , or refer to REMOVAL [10/2024 - ]

REMOVE INPUT SHAFT TYPE T OIL SEAL

Using a screwdriver with its tip wrapped with protective tape, remove the input shaft type T oil seal from the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Protective Tape

NOTE:

Be careful not to damage the input shaft assembly or hybrid vehicle transaxle assembly.

INSTALL INPUT SHAFT TYPE T OIL SEAL

Coat the lip of a new input shaft type T oil seal with a small amount of MP grease.

Using SST and a hammer, install the input shaft type T oil seal to the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Depth

SST: 09223-22010
SST: 09726-10011
1. 09726-00041

Standard Depth

1.9 to 2.7 mm (0.0748 to 0.106 in.)

NOTE:

Do not allow foreign matter to attach to the lip of the input shaft type T oil seal.
Do not install the input shaft type T oil seal at an angle.

INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
Refer to INSTALLATION [08/2023 - 10/2024] , or refer to INSTALLATION [10/2024 - ]