Caution / Notice / Hint
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection After Repair |
|
Refer to INITIALIZATION [10/2022 - ] |
NOTE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Refer to PRECAUTION [10/2022 - ]
COMPONENTS (REMOVAL)
| Procedure | Part Name Code | ||||
|---|---|---|---|---|---|
| 1 | REFRIGERANT FROM REFRIGERATION SYSTEM | - | - | - | - |
| 2 | SUCTION HOSE SUB-ASSEMBLY | 88704 | See step 2 | - | - |
| 3 | THROTTLE BODY WITH MOTOR ASSEMBLY | 22030 | - | - | - |
| 4 | E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR) | 89421 | - | - | - |
| 5 | PURGE VALVE (PURGE VSV) | 25860 | - | - | - |
| 6 | NO. 1 FUEL VAPOR FEED HOSE | 23826 | - | - | - |
| 7 | NO. 2 FUEL VAPOR FEED HOSE | 23827D | - | - | - |
| 8 | ENGINE WIRE | 82121 | - | - | - |
| 9 | NO. 1 EGR PIPE SUB-ASSEMBLY | 25601 | See step 9 | - | - |
| 10 | EGR VALVE ADAPTER GASKET | 25629 | - | - | - |
| 11 | EGR INLET GASKET | 25628 | - | - | - |
| 12 | NO. 5 WATER BY-PASS HOSE | 16281F | - | - | - |
| 13 | NO. 3 WATER BY-PASS PIPE | 16279 | See step 13 | - | - |
| 14 | NO. 2 WATER BY-PASS PIPE | 16278 | See step 14 | - | - |
| 15 | NO. 2 FUEL VAPOR FEED HOSE | 23827D | - | - | - |
| 16 | INTAKE MANIFOLD | 17111 | See step 16 | - | - |
| 17 | NO. 1 INTAKE MANIFOLD TO HEAD GASKET | 17177 | - | - | - |
| 18 | NO. 1 ENGINE COVER | 12611B | - | - | - |
| 19 | VACUUM HOSE | - | - | - | - |
| *A | w/ Stud Bolt | *B | w/o Stud Bolt |
| *C | for PHEV Model | - | - |
| • | Non-reusable part | - | - |