Removal [08/2023 - ]: Procedure

Refer to REMOVAL [08/2023 - ] 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A

   for Type A

   *B

   for Type B

   1. Disconnect the 2 fuel pump harness connectors and fuel sender gauge assembly connector.
   2. Disengage the 4 clamps to disconnect the wire harness from the fuel suction tube with pump and gauge assembly.
      NOTE:

      • Do not damage the wire harness.
      • When disengaging each wire harness from the clamp, disengage one wire at a time.
   3. Disengage the 2 claws to remove the fuel gauge bracket with the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

   4. Disengage the 2 claws to remove the fuel sender gauge assembly from the fuel gauge bracket.