LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle System - Service Information (1 Of 2)) >> Shift Paddle Switch >> Inspection [10/2022 - ] >> Procedure

Inspection [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Shift Paddle Switch LH (Transmission Shift Switch Assembly):
      1. Measure the resistance according to the value(s) in the table below.
        GTY772374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Shift Paddle Switch LH (Transmission Shift Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition Result
        1 (SDN) - 2 (ECC) "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω Ω
        1 (SDN) - 2 (ECC) "-" (Down shift) shift paddle switch not operated 1 MΩ or higher
        1 (SDN) - 3 (ECC1) "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω Ω
        1 (SDN) - 3 (ECC1) "-" (Down shift) shift paddle switch not operated 1 MΩ or higher

        HINT: 

        If the result is not as specified, replace the shift paddle switch LH (transmission shift switch assembly).

    2. Shift Paddle Switch RH (Transmission Shift Switch Assembly):
      1. Measure the resistance according to the value(s) in the table below.
        GTY757999Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Shift Paddle Switch RH (Transmission Shift Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition Result
        1 (SUP) - 2 (ECC) "+" (Up shift) shift paddle switch operated and held Below 2.5 Ω Ω
        1 (SUP) - 2 (ECC) "+" (Up shift) shift paddle switch not operated 1 MΩ or higher

        HINT: 

        If the result is not as specified, replace the shift paddle switch RH (transmission shift switch assembly).