Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

NOTE:

Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor) and fuel suction plate sub-assembly before performing this work.
Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor).
Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor).
After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor) cannot be pulled out.

*1	Tube Joint Clip	-	-
*a	O-ring	*b	Collar

Push the fuel tank pressure sensor (vapor pressure sensor) onto the fuel suction plate sub-assembly, then install the tube joint clip.
Connect the fuel tank pressure sensor (vapor pressure sensor) connector.

INSTALL REAR FLOOR SERVICE HOLE COVER
Refer to INSTALLATION [10/2022 - ]