Installation [08/2023 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR) NOTE:
- Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor) and fuel suction plate sub-assembly before performing this work.
- Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor).
- Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor).
- After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor) cannot be pulled out.
- INSTALL FUEL TANK COVER
Refer to PROCEDURE - Step 8 - INSTALL REAR FLOOR SERVICE HOLE COVER
Refer to INSTALLATION [08/2023 - ]